Skip to product information
1 of 1

Eco Fab

Valley Flashing - Safety Edge

Valley Flashing - Safety Edge

Regular price $18.50
Regular price Sale price $18.50
Liquid error (snippets/price line 124): divided by 0% off Sold out
Shipping calculated at checkout.
Gauge
Color

In stock

Shipping available at Shop location

View store shipping policy

Valley Flashing is an important component to your roof's flashing system.  It protects the critical area of the roof where two slopes come together to form a valley. When properly installed, this flashing will effectively direct the water run-off down the roof and into the gutters.

Closed valleys aren’t required to have metal flashing installed, but it is recommended that they have an additional underlayment lining. This could be a layer rolled metal flashing, peel and stick underlayment or other comparable product. You can typically see if this has been installed by looking carefully at the bottom edge of the valley.

Prior to installing this product, make sure you clean the valley from dirt and debris.  It is also recommended that you lay down some peel and stick roofing membrane under the flashing. As you install the valley flashing, take your first piece all the way to the roofs ridge, then install them over-lapping (top over bottom), from the top of the roof to bottom, until you get to the end. On the bottom section, cut along the drip edge to make sure water is diverted into the gutter system. 

Specifications

MaterialGalvanized steel (G90/AZ135)
ColorBlack and brown
Gauge30, 28 and 26 Ga
Dimension12 x 12 inch
Length8 feet
Pallet Size150 pcs
View full details